GENERAL DemoN cant grab handle in jrunner?

[Subflex8]

hey i just installed my DemoN into my trinity xbox that was already rgh and working fine. when i was done i got 2 nand dumps using the DemoN but now j runner says that is cant grab the handle or something. here are my qsb solder points and wires

really want to resolve this, please help

 

[Martin C]

Have you checked all points for continuity etc?

 

[Subflex8]

yes iv checked all my soldering for a strong joints and i think they are pretty solid

 

[Martin C]

Does the DemoN work ok? i.e can you boot from both the 360 and DemoN NANDs?

 

[Subflex8]

earlier i could but now i cant even turn the xbox on.....
when i first installed it i could get a nand read and everything just fine

 

[Martin C]

How have you checked for continuity?

 

[Subflex8]

i tested my joints with a multimeter

 

[stefanounick]

do you have toolbox open? JR and toolbox dont work together

 

[Subflex8]

actually yeah i did have them both open now that i think of it

 

[Martin C]

i tested my joints with a multimeter

That doesn't really tell me anything.

Tested from what to where?

 

[Subflex8]

i tested the qsb points and the nand poinds

 

[Martin C]

So you put one probe on the QSB point on the demon and the other probe on the corresponding pin on the NAND ?

 

[Subflex8]

yes. i didnt quite no what els to do haha

 

[Martin C]

Have you checked adjacent points for shorts ?

 

[Subflex8]

no but ill be sure to do that