Demon can't work

[karljhan]

I bought Demon(16SB) for my Jasper(512MB). it's real. My console is 512MB version but Demon is 16SB version

why I bought it. cause the vendor tell me "it's ok, them are the same"...

for that, i trust him......

but i can't turn on my Xbox360 when i installed Demon(16SB) even I'm crazed click the power button.

till I uninstall it.

does anyone can tell me, the 16SB can work on it (Jasper 512MB) or not????

 

[karljhan]

by the way, ask other question about this topic

My computer can't detected the Demon(16SB) when it connected with usb cable and installed on the jasper(512MB). i can for sure that demon already switch to pc mode

it's normal or not?

 

[XL3THAL VIP3RX]

by the way, ask other question about this topic

My computer can't detected the Demon(16SB) when it connected with usb cable and installed on the jasper(512MB). i can for sure that demon already switch to pc mode

it's normal or not?

if the demon is installed,the switch needs to be set to XB.
theres a card in the box saying warning.i would read it if i was you lol:rolleyes2:

and to top it off youve bought a small block demon and installed it on a 512 jasper that is a Big Block controller:facepalm:
somebody hasnt read the TuTs propaly and for that youve waisted £50 unless you can sell it or have another xbox to put it in

---------- Post added at 07:09 ---------- Previous post was at 07:04 ----------

I bought Demon(16SB) for my Jasper(512MB). it's real. My console is 512MB version but Demon is 16SB version

why I bought it. cause the vendor tell me "it's ok, them are the same"...

for that, i trust him......

but i can't turn on my Xbox360 when i installed Demon(16SB) even I'm crazed click the power button.

till I uninstall it.

does anyone can tell me, the 16SB can work on it (Jasper 512MB) or not????

no it wont

 

[karljhan]

yes, i am for sure it switch to xb, but it still can't work. therefor i re-solder three times. but the situation was the same. i'm very worry about 16SB can't work on 512MB version?

---------- Post added at 14:12 ---------- Previous post was at 14:10 ----------

oh~~ my god. why i trust the vendor ><

 

[big_ted]

the resistor configuration is different between bb nands and 16's, so there is the first stumbling block.

Ted

 

[karljhan]

thank!!! both of you. it's my fault, I should be check context of http://www.modsupplier.com/catalog/xecuter-demon-phat-p-997.html first.

BTW, my camera doesn't break but unsolder it ^^