ANSWERED Demon continuity check

[xzanox]

{{{ANSWERED}}}

Products used: NAND x and slim demon
console type: trinity 16 mb
dashboard 16537
cb: 9231

I haven't uploaded any jrunner logs since I think it's not really part of the question and I haven't installed any coolrunner yet etc...


Hi all, just to be on the safe side, i read my nands 4 times with the nand x in case anything should go wrong with the demon install. I only installed the demon, nothing else yet, but from what i have been reading it's smart to first check continuity.

So i have on every demon point continuity with the xbox nand and also on the demon nand, except for 1 point (CE point) circled in red. Edit: just to make clear, I have continuity from ce point to Xbox NAND but not to demon NAND...

I still have my nand x wires connected btw (In case i decide to put a cr3pro and use rater instead of a rev c, not sure yet, but that for i have the wires still connnected).

My feeling tells me the CE point needs also continuity with the demon nand, is that correct? And if so, what can i do about it?


Btw I am aware that I could have read the NAND with the demon, but was being cautious if I fail, at least I would have the original good NAND and not one with bad blocks or errors or whatsoever.

 

[Oggy]

Pin 34 is Chip Enable (CE) fyi.

 

[xzanox]

Pin 34 is Chip Enable (CE) fyi.

Ok I take that fmy (for my information lol) and is good to know, but I'm still unsure if this means I can continue or that I have to solve something.

What confuses me, is that CE point has continuity with Xbox NAND but not with demon NAND so not sure if this supposed to be like this?

 

[Oggy]

I just checked and no, there's no continuity from CE <-> Demon nand

- - - Updated - - -

I just checked and no, there's no continuity from CE <-> Demon nand

 

[xzanox]

Thanks oggy, also for checking it yourself.

Admin this thread is ANSWERED.