FIXED Demon CR3 Lite Trinity 4gb + QSB's install

[squeakh]

I will post pics later but I just wanted to see if this could be a soldering issue. I read nand and wrote it to demon and tried to boot stock from demon as a test. Boot fails with red dot on rol. Read nand again then read demon and compared nands and they do not match. Could this be solder issue on nand portion of demon install?

Also is there a method of checking demon for continuity or voltage and resistance using multimeter?

Another note is that the nand mismatch is on 0x0373 and 0x03DE.

Sent from my SAMSUNG-SGH-I747 using Tapatalk 2

 

[squeakh]

Sent from my SAMSUNG-SGH-I747 using Tapatalk 2

 

[squeakh]

I checked continuity for all points and I have a good connection on all my points so what could be the problem?

Sent from my SAMSUNG-SGH-I747 using Tapatalk 2

 

[squeakh]

Ok I realized stock nand flash to demon will not boot without keys. When flashing coolrunner should I use demon toolbox with demon xsvf or use jrunner? If I use jrunner should I do Rgh trinity with demon or Rgh2 c with demon like in the video? Also how does the coolrunner know when to glitch or standby does the demon tell it what to do and if so how do you tell it which side has glitch image (Xbox/demon)?

Sent from my SAMSUNG-SGH-I747 using Tapatalk 2

 

[BL4K3Y]

You can use J-Runner - it works perfectly fine with the DemoN.

Build and write an ECC image to the DemoN's NAND, program Trinity_EN.xsvf to your CoolRunner (Flash CoolRunner>Select Trinity>Tick DemoN).

Once done, boot into XeLL, obtain your console's CPU key, build a glitch image using the NAND dump you initially saved from the console and write it to the DemoN - don't forget to solder the CR_EN wire in place.

If everything went well, you should be able to boot retail from the console (LEDs off on the module) and the glitch NAND from your DemoN (blue LEDs on) - press the switch to select between the two NANDs.

 

[squeakh]

I understand the standard process but I couldn't glitch xell for some reason so I made a stupid mistake thinking I could just put stock on demon without keys. Now I can't figure out why it won't glitch. I have CR3 lite installed and led flashes on time but fan speed is soaring and it won't boot xell. I have shielded wire from xconsoles also.

I have the ribbon cable plugged into the CR3 although not present in the pic and I tried all pads on the post qsb for cpu rst. What should my settings be on the CR3? I have lk1+2 bridged also.

Sent from my SAMSUNG-SGH-I747 using Tapatalk 2

 

[squeakh]

FIXED

i programmed the cr according to kiel423's video tut and bridged lk4 1+2 and everything is golden now. also i put the cr3 lite's switches off except for the1 and 5 bypass switches. thanks