[Demon] Fatal Error!

O

oO DI2eamZz

Noob Account
Aug 29, 2012
7
0
Here's the story, I have had my DeMon dual nand Trinity RGH for almost a year now. But, I have never used the stock nand side of it.

Today I did the update to dash 16537 on the stock nand side, everything went smoothly and both NAND's worked and I was able to play on both as well.

Went to update the demon rgh side via J-Runner and installed the demon drivers and everything was recognized correctly. Half way through Reading my NAND JRunner closed and my PC made the sound that my usb had been disconnected.

Now my laptop will NOT recognize my demon, nor will it allow me to switch NAND via the button on the back. I feel like I erased everything from the chip.

I dont want to open the RGH to take pictures seeing as Im 100% positive that it isnt a soldering issue

Thank you so much in advance for all your help :)
 
G

gavin_darkglide

VIP Member
Dec 14, 2012
2,303
118
Im thinking since you are asking for support for your demon then pictures of that install would be a good place to start, also your coolrunner install. I would try putting the demon in bootloader mode and see if your computer recognizes it then. if it does just reflash latest firmware, and that should work.
 
O

oO DI2eamZz

Noob Account
Aug 29, 2012
7
0
Utmad said:
all soldering, wire routing, demon, coolrunner
Click to expand...
This is weird, I've figured it out myself though.. But for reference if someone else stumbles on the thread with the same issue

Unplugged Power Supply from back of 360
Unplugged it from the wall until the brick had 0 power
Plugged everything back in, and booted RGH with no result

But

It did show up in J-Runner and I was able to reflash a proper image to the demon and it worked like a charm
 
You must log in or register to reply here.