hey guys, recently brought a demon n installed it and it wont boot with my cr3 pro.. i installed all my glitching devices first, and tested n manged to get it boot pritty much every 2-3 glitches..!
Motherboard is a Corona V1 With 16Mb Nand..
i then tried to install the demon but came across this problem... looks like some1 lifted the pad next to the nand where the demon installs.. is there anyway around this like a wired install etc.. console still boots and is fine still glitching. i just want the demon installed so i can switch to retail.
Heres The Missing Pad...!
heres my cr3 pro install..!
Ive been reading and came across this post... http://team-xecuter.com/forums/show...1-Demon-wire-install-pics?p=699305#post699305
an i right in thinking that i can do an install like this with the demon and not have to use any qsb?? and do an install like this..??
Thanks In Advance...!
Motherboard is a Corona V1 With 16Mb Nand..
i then tried to install the demon but came across this problem... looks like some1 lifted the pad next to the nand where the demon installs.. is there anyway around this like a wired install etc.. console still boots and is fine still glitching. i just want the demon installed so i can switch to retail.
Heres The Missing Pad...!
heres my cr3 pro install..!
Ive been reading and came across this post... http://team-xecuter.com/forums/show...1-Demon-wire-install-pics?p=699305#post699305
an i right in thinking that i can do an install like this with the demon and not have to use any qsb?? and do an install like this..??
Thanks In Advance...!
Last edited:
