Demon installed, Ran Jrunner, quick Question

[THshadow]

Hey Guys,

I just installed the demon and had to do an alt point on the nand it self but I finally got it to read in Jrunner. Here is the output.

It said they were the same which is good I think but the part that concerned me was "Header is wrong"

Should i proceed or is there something wrong?

===================================================
Monday, December 31, 2012 10:56:41 AM

J-Runner v0.2 Beta (284) Started


Connection Error
Checking Files
Connection Error
Reading Nand to C:\Users\Amanda\Desktop\J-Runner v02 Beta (284) Core Pack\J-Runner v02 Beta (284) Core Pack\J-Runner v02 Beta (284) Core Pack\output\nanddump1.bin
DEMON
Hardware   : Demon Slim
Firmware   : 1.0
Flash ID   : 0x73AD Hynix (16MiB - Small block)
Flash Size : 0x400 blocks of 0x4200 bytes
Reading Nand
Done!
in 0:28 min:sec

Reading Nand to C:\Users\Amanda\Desktop\J-Runner v02 Beta (284) Core Pack\J-Runner v02 Beta (284) Core Pack\J-Runner v02 Beta (284) Core Pack\output\nanddump2.bin
Initializing nanddump1.bin..
Reading Nand
Header is wrong..
Done!
in 0:28 min:sec

Comparing...
Nands are the same

 

[alexander_1333]

Load your nand in j-runner and take a screenshot.
Header is wrong error comes from an ecc-ed nand.

 

[THshadow]

Update:

Switched to the xbox 360 nand and got the message "manufacturer for code 3F not found" so i guess the wiring is messed up somewhere :/

I'll keep trying!

 

[Martin C]

No, there's nothing wrong.

You should be following a 'common sense' approach for testing the DemoN.

If you don't know what that could possibly be, get it to a pro installer.

 

[THshadow]

It was a simple question

When one thing says "wrong" and another says "same" its a little contradicting

 

[frazzeld]

Its a Bandwith Error in JRunner..... happens occasionally

 

[Martin C]

You're getting 'header is wrong' is because you're apparently trying to read and validate an empty NAND. You should know this already, hence curious as to why you started a thread with the question and no pics of your install or results on continuity checks between the NAND points and the NAND itself.

 

[dateq]

"manufacturer for code 3F not found" means your connections to the nand on the board aren't okay.

I recently had to solder a DemoN Slim into a Phat box (Lack of funds and I was in a experimental mood) and it gave me that exact error. Even when I redid all the solder-joints it still gave me that error.

I just had to do them all AGAIN and AGAIN and then it worked.

9 out of 10 times problems that arise are solder problems.