FIXED Demon? More like Nightmare

C

Crazywhitie

VIP Member
May 7, 2007
231
0
USA
Ok First I was getting Red Dot with CRvC.. Now upgraded to CR3lite..

Was Working Fine other then Random Boots Times.. But now out of no where. Demon won't boot RGH Nand lol..

System just Beeps.. but will boot Original nand fine still..







This is getting old
 
L

LoneWolf913

See if you can read the Xbox nand via the Demon. I'd bet you can't. Looks like D0-D2 need to be re-soldered from the pics..which would explain not booting the Demon nand.
 
C

Crazywhitie

VIP Member
May 7, 2007
231
0
USA
Messed with those Points.. And it boots.. Why work it work fine for 3 days other then a random E72.. .. Weak Solder Points?
 
L

LoneWolf913

Yup, solder probably was thin or brittle to start with and there may have been tension on the Demon board itself if it wasn't installed perfectly flat to begin with, which can and will make those bad joints disconnect. Glad you sorted it, I'll have to add E72 to the personal database of Slim error codes as a nand/southbridge issue as well, knowing that.
 
C

Crazywhitie

VIP Member
May 7, 2007
231
0
USA
LoneWolf913 said:
Yup, solder probably was thin or brittle to start with and there may have been tension on the Demon board itself if it wasn't installed perfectly flat to begin with, which can and will make those bad joints disconnect. Glad you sorted it, I'll have to add E72 to the personal database of Slim error codes as a nand/southbridge issue as well, knowing that.
Click to expand...
Yeah the E72 only happen once, I just unplugged and tried again. then all was Fine.. Thanks for seeing those Weak points.. I'm going to test tonight clean up a few things.. Then I change to Fixed..
 
You must log in or register to reply here.