Demon Nandswitcher not working

[Scrufdog]

Cant get the Nandswitcher software to work. It shuts down the console, switches NANDs, never restarts, then a few seconds later it switches NANDs back to Demon.

X7 and X8 are wired per a diagram I found on the net, however, X8 I have discovered is soldered to 3.3v standby, as opposed to the non standby specified. Where might one find a 3.3v non-standby on a Corona v5?

 

[gavin_darkglide]

you want x8 wired to a non stand by power source, this tells the demon that the power has shut off, and it can change the nands. your problem is most likely revolving around the x7 wire. easy test....... plug demon in to jrunner. in the demon menu press power on. The console should boot, but if i am right it wont.

 

[Scrufdog]

You are correct. I installed following the corona sticky in this forum. Anyone know the correct spots for these wires on this v5?

 

[Martin C]

power only 3.3v is right next to stby 3.3v on that header. A 2 minute check with a multimeter will confirm this.

 

[Scrufdog]

I did check with a meter. I'll go check again.

 

[gavin_darkglide]

The X7 wire goes to the same point as the K point on the CR3-pro.

 

[Scrufdog]

On mine, X8 is indeed soldered to a non standby 3.3v at pin 8. X7 is soldered to pin 11 which shows 3.3 constant. Also, Demon was updated to 1.04 awhile ago

 

[Scrufdog]

Hmm... Perhaps that is the problem. This has the TX Prototype on it.

 

[Scrufdog]

R2C4 needs a bridge. I'll hit that and that should be it. After saying the TX might be it, I thought about it some more and realized that shouldnt matter at all, since the Demon is sending the power signal.

 

[Scrufdog]

We're good. I do know why I missed it. While reading the Corona ID guide it said R2C4 was for Rater, and I knew I would be installed the TX Proto with no Rater. Didnt realize it was for the Kiosk.

 

[Martin C]

Yeah, it's needed for RATER to start the console