GENERAL Demon not working anymore, Help with multimeter please

[whataretheyfeedingyou]

so my demon slim has stopped working. it now just bings with no power so I suspected a short some.

I've refowed every solder point and still the same so I have gone out and bought a multimeter but have no idea how to use it for to find the cold point.

I've checked continuity with it and it didn't buzz obviously. but how would I go about finding the exact one? if I can that is?

 

[jimlfixit]

for continuity checks, you really do need a buzzer on your multimeter. Desolder all the wires and put the demon on PRG and see if the console boots.

 

[whataretheyfeedingyou]

I have a buzzer on it. desolder just the wires? and by prg mode do you mean PC mode?

---------- Post added at 12:14 ---------- Previous post was at 12:13 ----------

I know there is no continuity, I'm trying to find the dry point

 

[whataretheyfeedingyou]

well wires are all off. and its still the same

 

[BL4K3Y]

Test each DemoN quick-solder pad (excluding the anchor point) against the alternate points.

I'm assuming STBY_CLK is still intact?