Demon Reads nand but - all bad blocks Trinity

P

PCP008

VIP Member
Dec 1, 2011
275
0
UK
Well I installed my demon, in combination with a revc coolrunner I programmed the coolrunner chip to a trinity.

I read the demon nand and that was all clear.

I then read the xbox 360 nand and at first I was given the error message after two reads " can't check for bad blocks. no spare data. possibly corona 4gb on trinity "

However after reading the xbox nand two times again they compared and Jrunner displayed that every block was bad.

I'm thinking should I re-solder the nand read point wires. Or is this a ribbon cables issue. Anyways not sure request anything below you want to see to help me out thanks.

EDIT: USED ALT WIRING DIRECT TO RESISTORS AND NAND PINS NOW WORKS
 
Last edited:
Martin C

Martin C

VIP Member
Jan 10, 2004
35,981
0
Scotland, UK
www.team-xecuter.com
As PM'd - you need to check the installation as it's soldering related. Error FF means something's not right.

Pics of the install would also be useful.
 
P

PCP008

VIP Member
Dec 1, 2011
275
0
UK
Martin C said:
As PM'd - you need to check the installation as it's soldering related. Error FF means something's not right.

Pics of the install would also be useful.
Click to expand...
Error FF is not being displayed that was from the log before Martin..

I resolved that issue it was a ribbon cable issue leading to the module
 
Martin C

Martin C

VIP Member
Jan 10, 2004
35,981
0
Scotland, UK
www.team-xecuter.com
ok - either way I'd still check continuity on all points.

This is what your header looks like:

‰ 2004-2010 mIcrOsoft cOrporatioN. aLl rights reServed. ........

This is what it *should* look like:

© 2004-2010 Microsoft Corporation. All rights reserved..........

So you have an issue with one of the I/O lines (best guess).
 
You must log in or register to reply here.