Demon to read/write Nand only

[blakhawk]

I don't have JR-P, or NandX. I want to use the Demon for reading and writing the Xbox NAND only (wire soft install) and programming the CR3Lite. Once I get this done I will remove the demon from the install.

Is there a diagram to show the minimum wires that need to be soldered to achieve the read/write?

Thanks for any help provided.

Cheers

 

[jery911]

why not just get a jr programmer v2 there only $25 bucks. it would make things alot easier.

 

[oO Elite Oo]

Not a good idea, best to get JRPv1 or v2 (for rater + its faster than v1).

 

[blakhawk]

I will in the near future but the Mrs is getting pissed at how much I am spending lately so am trying to work with what I have. As they say "happy wife, happy life"

 

[XDK]

Mininum wires to hookup

d0-d7 / wp/ we/ ale/ cle/ rb/ vcc 5v / gnd/sbr

 

[Martin C]

basically everything except RX, TX, Sync and Kiosk.

 

[xboxhack11]

I will in the near future but the Mrs is getting pissed at how much I am spending lately so am trying to work with what I have. As they say "happy wife, happy life"

I suggest you put your pants back on and let her know who is the king of the castle over there or you are going to have problems, LOL