Demon Trinity Not Glitching With CR3 Lite.

[Nadles]

Hey guys. I have recently acquired a Trinity 250gb and was attempting to Demon with a CR3 Lite. I started last night and installed everything nicely. It's my first demon I've personally done but I have done tons or Coolrunner installs. Now I highly doubt its a connectivity issue because I have tested every point but I am willing to post pictures if need be. It boots to stock nand no issue. When I program the coolrunner to the trinity Xsvf file and write the ECC to get my keys it attempts to glitch but fails. I have set the Coolrunner to
S2 1,5
S4 None.
LK1 bridged
LK2 bridged
LK3 Open
LK$ 1&2 bridged
Setting is on Slim I have tried both Slim & Phat
Dashboard 16203

It reads the nand perfectly with the external USB connector. I have re done the Ribbon cables ten times and switched ends. I need any help anybody can provide. I have tried numerous wire lengths for D. 50 CM coil. 15cm short as possible. everything. Also tried ALT standy clock point. I need any advice anyone can provide.


http://imageshack.us/photo/my-images/547/dscn0515d.jpg/
http://imageshack.us/photo/my-images/832/dscn0507u.jpg/
http://imageshack.us/photo/my-images/96/dscn0505li.jpg/
http://imageshack.us/photo/my-images/69/dscn0503m.jpg/
http://imageshack.us/photo/my-images/20/dscn0501pf.jpg/
http://imageshack.us/photo/my-images...scn0496ry.jpg/
http://imageshack.us/photo/my-images...scn0494xm.jpg/

Excuse the terrible quality. So You know I believe it is the coolrunner because It will not glitch via the xbox's nand either.

I'm going to have to find my J Runner log and repost but there wasn't any errors. Flashed the Coolrunner fine and read nand perfectly and wrote ecc fine.

EDIT: Solved by wrapping CPU RST around xclamp.

 

[Usmcmods]

glad to here it.

 

[Krafter]

Will it boot stock form the Demon with the CR in program?

Tapatalk misspelled it. Knot me.