So i have Demon on Trinity with Coolrunner 3 Lite on dash 16203, installed Demon , dumped nand twice and nands are the same!!! , installed coolrunner 3 Lite whit jumper settings lk1 and lk2 bridged lk3 lk4 open as suggested in jumper setting coolrunner 3 lite thead and coolrunner 3 Lite is connected with ribbon cable to Demon , wrote original nand dump on demon tested and works fine on tv unit, then wrote rgx trinity ecc on demon nand message succesful in j-runner, flashed xsvf demon_trinity and also tried trinity_en xsvf file, green light on coolrunner flashed and message in j-runner was succesfull for programming xsvf file. Then i turned on the Xbox 360, coolrunner debug green light flashes no problem but never glitches, green light flashes even after 10 min tried it like 3 times, should i put coolrunner rev C instead of 3 Lite on this Trinity board or maybe use DGX chip that i already used before these files were released, my cpu reset ( blue wire ) lenght is the original lenght that comes in the package of the coolrunner 3 lite slim wires, any suggestion would be gratefull, thanx 
Last edited:
