DEMON WIRE
- Thread starter XxGLITCH3RSxX
- Start date
There is this but you did not say what system you have.
http://team-xecuter.com/forums/showthread.php/97013-Corona-v1-Demon-wire-install-pics
http://team-xecuter.com/forums/showthread.php/97013-Corona-v1-Demon-wire-install-pics
i dunno what motherboard it will be yet need to see what stock i get but it will defo be on a phat motherboard do you have a diogram for the phat motherboard please thax
The only points on a phat are the nand points and the wire points, do the wire points as normal and for the nand points, do each nand point to the large pads on the demon beside each point.
make sense?
EDIT: if I make a picture, do you want top side or underside points
make sense?
EDIT: if I make a picture, do you want top side or underside points
Last edited:
Martin C
VIP Member
I'm not sure what you're asking for.
The DemoN has all NAND points CLEARLY marked on them. You just match them up with the NAND on the console.
The DemoN has all NAND points CLEARLY marked on them. You just match them up with the NAND on the console.
Demon wire install on a phat is a bitch unless you go directly to the test points in the underside of the board. Screw those up and there are no alt points for some of them. You'll be stuck with soldering directly to the NAND which is no fun at all.
Buy a phat demon and be done with it.
Tapatalk misspelled it. Knot me.
Buy a phat demon and be done with it.
Tapatalk misspelled it. Knot me.
Martin C
VIP Member
FTR, for those of us who can solder at a good level, installing a DemoN when the via points are lifted is easy enough and doesn't require tons of bypass wire. OP - if you need a DemoN installed on this, drop me an email.