Demon with CR3 lite on phat jasper 16 mb

[Wolf3d]

hi , just installed the demon and the cr3 lite, now i got a few things to know. when plug in first time red and green light on on cr right? so now i read the nand of xbox, blue light off... 2 reads, nand are the same, then i push flash CR, green light goes off. should i have first change to demon an then flash cr? anyway jr says xsvf send to demon .. done. this is how far i am at the moment. now my dash is 8498 and cb is 6750, can i follow up or do i have to do something else first?

 

[Martin C]

Have you tested the DemoN by writing your console's NAND to it?

 

[Wolf3d]

only read the xbox nand so far, did not write anything yet to demon

 

[Martin C]

Why not? Don't you want to make sure it works?

 

[Wolf3d]

so ok u mean , load nanddump1.bin in source, switsh to demon and write?

 

[Martin C]

Yes, that's generally how we write a NAND.

You are aware that DemoN installs are not for noobies for this very reason. Did you read the card?

 

[Wolf3d]

yes i did, i am only asking to make sure everything goes right

 

[Martin C]

So in which case, all read/writes are now to the DemoN so you can't mess much up from here.

Just carry on as per normal but remember if you want this to be used for XBL, you'll need to update it to 14719 at some point and wire it for RGH2.

 

[Wolf3d]

ok martin, only using it offline for now, hmm the box not power up, got the motherbord on the table, power and hdmi cable pluged in

 

[Martin C]

So what have you done since it last worked?

I'm assuming you followed the CR3 Lite settings guide to set up before install? I assume you at least read it?

 

[Wolf3d]

yes i did all the settings to the cr, i just was writing the nand to the demon, last time the box was runing before i open it and installed the demon and the cr

 

[Martin C]

So you have to work backwards then.

Help is extremely limited when you're not supplying any proper information.

What settings did you change on the CR3 Lite? Pictures would be handy too.

 

[Wolf3d]

setting for the cr i made is LK1 + LK2 short, lk3 and 4 open, s2 = 1 and 5 on, s4 = 5 on, i will check everthing again and come back with pics, thx for help