Demon Wont Recognize in Windows after Install - Initial tests Good

[CEEHRIS604]

I am looking for help as I intially tested the Demon both with the microusb and the ribbon and recognized in Demon Toolbox but after install it will not recognize in Demon Toolbox. I do not get LED's on the Ext Module. My soldering is okay I think. It is a Jasper with RGH 2. Any ideas?

Is it possible to manually flash the Demons Nand with Nand-X if need be?

http://s17.postimage.org/xkzxaj33j/IMG_0184.jpg
http://s16.postimage.org/detrekaj9/IMG_0186.jpg

 

[BL4K3Y]

Take some close-up photos of the quick-solder points and re-solder your 5v STBY (red) wire (try tinning it first).

Also check that you grounded the external module and that the ribbon cable is inserted correctly and firmly.

 

[Martin C]

Soldering is awful. I'm assuming you've carried out all the necessary continuity checks between QSB and console as well as between the DemoN and USB board?

 

[snake007]

I would definalty say it is the soldering. This happened to me the other day. After i unistalled it cleaned it all up and had another go it worked fine. There is probably a small bridge somewhere.

 

[CEEHRIS604]

I removed the demon completely and it is recognized via the Micro USB but not the External Module.