ok how would i go about lifting the demon off the board an resoldering it back . i know u have to desolder it but that does not work that great . i hear it need to be done with heat
GENERAL demond remove
- Thread starter skater411
- Start date
- Status
Martin C
VIP Member
You don't need to remove and resolder.
This thread will now be closed. It's obvious you are not skilled enough to be even attempting this, which is completely against the advice on the card. Therefore support is now at an end.
I suggest you post in the 'request a service or item section to get someone to sort this for you.
This thread will now be closed. It's obvious you are not skilled enough to be even attempting this, which is completely against the advice on the card. Therefore support is now at an end.
I suggest you post in the 'request a service or item section to get someone to sort this for you.
- Status