Device Not Found. Exited!

[DR-Dylan]

Made it all the way to the final step in Jrunner, however when I click 'Write Nand' I get a message in Jrunner: Device Not Found. Exited!

I think I messed up my NAND-X when I did not disconnect it from my QSB and Coolrunner when checking the Xell-Reloaded blue screen on my monitor after I powered on my xbox.

Anything else I can try? Can NAND-X be reset? Is that the little hole on top of the NAND-X? Do I just press it while connected to Coolrunnen and QSB?

If I buy a new NAND-X, where do I pick up my steps in Jrunner?

Thanks

 

[playingmax]

just copy nandflash and xenon to a usb drive and start xbox w/ eject.

 

[Statecowboy]

Did you write your original nand back after you booted to Xell? If not, you dont need to press eject, just press the power button to boot to xell again.

As mentioned above, you can write to your nand with your created J-runner image on a flash drive renamed "nandflash.bin" and place it on the root with "xenon.elf"

Also, I should add chances are you did mess up your nand-x. If this is the only console you're doing you dont really need another one. However, if you intend on reading/writing more nands, then you'll need to order another cause your r/w capability is now gone.

 

[DR-Dylan]

Thanks. That seemed to work. I got to the black screen up to where it says ' shut down now'.

How can I now visually confirm my RGH was successfull?

 

[Statecowboy]

Reboot!

 

[DR-Dylan]

I guess I did it. Xbox boots perfectly to Dash. One more question before I close everything up: do I leave the Coolrunner switch to NOR or PRG?

---------- Post added at 20:42 ---------- Previous post was at 20:41 ----------

Just RGH'ing my own xbox.
Thanks

 

[Statecowboy]

If you wrote the J-Runner created image, then you are RGH'd. So yes, leave the CR in normal. Go run some homebrew.

BTW - you are lucky you screwed your nand-x up after you got Xell loaded, .

 

[duffman452]

Just for a heads up if you have a ck3 to nand x and a ck3 you could probly reflash the 3.0 firmware to get it working again. Just a possibility though if u dont have the ck or ck to nand x, its cheap to just get a new nand x.

 

[Statecowboy]

Just for a heads up if you have a ck3 to nand x and a ck3 you could probly reflash the 3.0 firmware to get it working again. Just a possibility though if u dont have the ck or ck to nand x, its cheap to just get a new nand x.

You do realize this is a RGH issue right?

 

[duffman452]

You do realize this is a RGH issue right?

You do relize i was commenting on the broken nand-x and a potential way to fix it? Since you seemed to of solved the problem i just posted about how he could potentailly fix his nand-x.

 

[QcMarque]

You do relize i was commenting on the broken nand-x and a potential way to fix it? Since you seemed to of solved the problem i just posted about how he could potentailly fix his nand-x.

if the nand-x is not seeing any controllers anymore, then it's not a firmware issue with the device... re-writing the nandpro 3 code to the device won't help.

If it was an issue with the code, it would mention a non-compatible device instead