my lite-on DG-16DS2 wont eject since updating process from game fifa11 ?
what should i do, please help..!
what should i do, please help..!
DG-16D2S wont eject
- Thread starter Ureng Uten
- Start date
you mean i have to reflashed my drive again ???
i'm a noob, please help...???
---------- Post added at 16:07 ---------- Previous post was at 16:04 ----------
i'm a noob, please help...???
---------- Post added at 16:07 ---------- Previous post was at 16:04 ----------
you mean i have to flashed my firmware again ???
Was it a game update or a dash update?
If it was a dash update which dash were you on before?
If it was a dash update which dash were you on before?
the drive just wont move, even a single blink....
i'm a noob, please help...???
---------- Post added at 16:12 ---------- Previous post was at 16:08 ----------
it is from the cd game i think, because it asking for an update when i insert it...
i'm a noob, please help...???
Still could be a dashboard update. Which dashboard were you on before it asked for the update? Did the update complete the first time it asked for it?
If it's a failed update
Try this...
Clear Any Failed system updates that cause the console to error.
1. With the console off, press and hold the sync up button (the small one which you connect the pad with)
2. While holding the sync button press the power button to turn on the console
3. Continue to hold the sync button until the Console has booted up completely.
4. During the boot process the console should clear any failed updates, allowing you to use it normally.
(copied from el nino post to save time)
Not sure that that's the problem but woth a try first off
If it's a failed update
Try this...
Clear Any Failed system updates that cause the console to error.
1. With the console off, press and hold the sync up button (the small one which you connect the pad with)
2. While holding the sync button press the power button to turn on the console
3. Continue to hold the sync button until the Console has booted up completely.
4. During the boot process the console should clear any failed updates, allowing you to use it normally.
(copied from el nino post to save time)
Not sure that that's the problem but woth a try first off
Last edited:
thanx for your advice, n i have done it... but seem its still there...
i even cannt move the drive permanently, its absolutly wont eject...
and what should i do anymore my wise friend...???
fiuh, is surely have to upgrade my firmware back days !
i'm a noob, please help...???
Ok best to flash your drive back to stock to rule out any firmware issues. If you flash back to stock then update the xbox to the latest dashboard 14699 you will see if it is a hardware issue. These two things will rule out firmware or failed update issues. If you still have issues then it is your disc drive failing most likely.
Once these steps are done (if it fixes the issue) you're in the clear to flash to lt3.0 and everything will be up to date.
Let us know how it goes
Once these steps are done (if it fixes the issue) you're in the clear to flash to lt3.0 and everything will be up to date.
Let us know how it goes
I had a similar problem with my DG-16D2S 0401 drive. Everytime I'd eject the rol would bling but the tray wouldn't open.
I was using a replacement pcb with the solderless adapter. I soldered the wires onto the pcb and discarded the adapter.
This solved my problem. Hope this helps
I was using a replacement pcb with the solderless adapter. I soldered the wires onto the pcb and discarded the adapter.
This solved my problem. Hope this helps