DGX Dgx - corona v1

[jligg]

Anyone know of an alt point for the dgx on corona v1 mb that works well. Is removing the xclamp a must?

 

[Martin C]

Read the DGX FAQ thread.

 

[jligg]

I did. Only alt point I see them talking about is ft4r2. Is that for the Corona as well? Cause in the thread it was talking about that point for trinity

Sent from my ADR6400L using Tapatalk 2

 

[Martin C]

any of the CPU_RST points normally used for corona should work.

Search 'corona CPU_RST'.

 

[XEX DriZzy]

You don't have to remove the x clamp in order to solder that point for the DGX. Just get a good light so you can see the point, tin the wire, add flux to the end of it and just solder under the x clamp. Not too hard.

 

[jligg]

Ah nice... Will do that.

Sent from my ADR6400L using Tapatalk 2

 

[Steel City Mods]

Why are people still so afraid of removing xclamps? Ifs understandable that many people have damaged their boards in the process. I myself have never did any damage, even with a screwdriver, but the tx unlock tool makes its so easy. Or is because of the extra 30 seconds of work that that goes into the job?

 

[XEX DriZzy]

Why remove the x clamp when soldering under it is easier than removing it? I personally don't have the removal tool which makes it a real pain.

 

[Steel City Mods]

Why remove the x clamp when soldering under it is easier than removing it? I personally don't have the removal tool which makes it a real pain.

Not saying or implying to the OP that the xclamps need removed.. just curious why people are so against it. And i dont have the tool either, i unclamp them with a small flat headed screw driver, takes 15 seconds.

OP, you can do it without removal of the clamp, i prefer to take them off to give myself room to work.

 

[FlipMode]

Not saying or implying to the OP that the xclamps need removed.. just curious why people are so against it. And i dont have the tool either, i unclamp them with a small flat headed screw driver, takes 15 seconds.

OP, you can do it without removal of the clamp, i prefer to take them off to give myself room to work.

I totally agree with you, it's no big deal to remove the clamp. People with poor soldering skills will screw it up not removing the clamp in my opinion.

 

[playingmax]

here you go
http://img.photobucket.com/albums/v647/bonomax1itpics/coronaboard_zps6476e077.jpg

 

[jligg]

I'm not worried about removing the xclamp. I'll use either point. But if I can get the same effect without removing it then why not

Sent from my ADR6400L using Tapatalk 2

---------- Post added at 22:02 ---------- Previous post was at 22:00 ----------

here you go
http://img.photobucket.com/albums/v647/bonomax1itpics/coronaboard_zps6476e077.jpg

Thanks

Sent from my ADR6400L using Tapatalk 2