DGX dgx corona v4 won't glitch

[WalangAlam]

tried 8cm cpu_rst to ft3t10 and r4p5, also original slim blue wire.

tried 120cm and above for post out, tried also original yellow post out wire

8 on

r2c6 r2c7 bridged

hdmi inserted

didn't experience the ticking sound of the fan

waited for 10mins or more for each setup of wirings

qsb for reading nand removed

Just green and no glitch.


Checking Files
Initializing corona4hruet.bin..
Finished Checking Files
Nand Initialization Finished
Writing to F:\ from C:\J-Runner\common\DGX\CORONA_4GB_DGX.ecc
Done!
in 0:03:574 min:sec:ms
Writing to F:\ from C:\J-Runner\common\DGX\CORONA_4GB_DGXv2.ecc
Done!
in 0:00:487 min:sec:ms

 

[jligg]

Use c5r11 point and cut your post and cpu_rst wire as short as possible

Sent from my ADR6400L using Tapatalk 2

 

[Martin C]

Have you also checked with a meter to ensure your bridges are good?

 

[WalangAlam]

Use c5r11 point and cut your post and cpu_rst wire as short as possible

Sent from my ADR6400L using Tapatalk 2

Thank you so much. Got my key in just under a minute. I lost 12hrs and sleep because of this corona. Solved thanks to you.

Now for the cr. I hope I won't spend another 12hrs

 

[jligg]

You should definitely read everyone else's success story but ill tell ya mine. Not saying it's what you should do but it's what I use.

I use the 4.3 timing file and use knyar wire wrap 30 awg for the post and cpu_rst. I cut them to length and I use the alt point for cpu_rst. I've done about 9 corona the past week. All of them pretty much instant boot. Every now and then it will make it to the second pulse but that's it.


Sent from my ADR6400L using Tapatalk 2

 

[pengekcs]

I will give the 4.3 timing a try. I wonder if it will give me instant boots. I tend to use 2.3 timing which is kind of OK, always boots (using same wiring as you jligg) sometimes instant sometimes takes 1 minute or two, but it does boot. Never tried 4.3 - thx for the tip