I got a question. This is my first DGX install because of the higher dashboard 16197 and a 0502 drive in this Trinity Slim but done other RGH en JTG install's before.
I backupped the nand a few times to make sure they are identical, after that i flashed the DGX ecc file to nand and installed the DGX.
i tried 75 and 55 cm for POST OUT
i tried the ground cable (from another set) for CPU RST on FT4R2
i tried blue 10cm cable CPU RST to C5R11
As stated in the troubleshoot thread
After a couple of cycles the green debug light goes out and the fan on the cpu ticks.
Does that mean the wires are soldered correctly AND the DGX tries to do it's work AND the nand is correctly injected with the DGX ecc BUT the wires length must be tweaked?
I really want to know because i already spent a couple of hours on this one and it's making me nuts.
I already ordered the QSB V3, QSB POST, COMM, xecuter shielded slim cable and CPU reset cleaner yesterday so they should arrive this afternoon (i hope) by postal mail.
Right now i'm going to the shop to get a 10pf capacitator.
I backupped the nand a few times to make sure they are identical, after that i flashed the DGX ecc file to nand and installed the DGX.
i tried 75 and 55 cm for POST OUT
i tried the ground cable (from another set) for CPU RST on FT4R2
i tried blue 10cm cable CPU RST to C5R11
As stated in the troubleshoot thread
After a couple of cycles the green debug light goes out and the fan on the cpu ticks.
Does that mean the wires are soldered correctly AND the DGX tries to do it's work AND the nand is correctly injected with the DGX ecc BUT the wires length must be tweaked?
I really want to know because i already spent a couple of hours on this one and it's making me nuts.
I already ordered the QSB V3, QSB POST, COMM, xecuter shielded slim cable and CPU reset cleaner yesterday so they should arrive this afternoon (i hope) by postal mail.
Right now i'm going to the shop to get a 10pf capacitator.
