DGX DGX + Postfix does not rise xell

[Feolca360]

Hello everybody, I'm here with a dash V4 Corona 16202, DGX and Postfix, but is not rising to xell, is 2 hours and no xell, is only glitcheando, install mode follows the photos.

Gotta make jumper somewhere? or put resistors?

 

[Oggy]

bridge R2C6 / 7

 

[Steel City Mods]

Thats an awefully long post out for a corona.. The v4 i did, i used 12 or so cm of wire. Id try shortening it up. Of the few coronas ive done, none have.taken over 2 minutes.

Edit: didnt even notice that r2c6 and r2c7 were unbridged. Bridge those as Oggy said.

 

[Feolca360]

Ohhh, Thank you, now it worked, you saved my life!! kkk

 

[Steel City Mods]

Glad you got it working.

 

[udfottah]

tnx for the tip igot my cpu key.

 

[Manmeet]

Tks oggy got mine too working.....(same issue)

 

[Martin C]

Tks oggy got mine too working.....(same issue)

Yep - some of you really need to read the guides we post on here.

 

[oztony]

After cpu key is obtained do we unbridge r2c6 and r2c7 if not RHG using for ODE ?Also mines a v3 do I have to bridge r2c10 for the DGX to work?
Thanks Tony

 

[bmonier]

keep it bridget .

 

[oztony]

Thanks bmonier being a v3 do I have to bridge r2c10 for the DGX to work?


Thanks Tony

 

[Amarok]

r2c10 is for nand read/write.... do u ppl read?

 

[oztony]

I have done a fair bit of reading there is not much referance to the resistor bridging and its effect on the operation of the DGX WITH A v3 Corona MB.:smile: