nope againI highly dought thats the problem but hey you never know
---------- Post added at 22:17 ---------- Previous post was at 22:16 ----------
well im confused what happens if you unplug your avi do you get 4 red rings or the same thing?
lol its been booting.......Try flashing your original nand to the xbox and switch the coolrunner to prg see if it boots
well wrote last image,new image, then original nand back with nand x... lol the lights stayed on throughout the entire write
yes both xell and dash
lol maybe try putting the original nand back and see if the lights are still screwed up. If you care that much about the lights. I kinda like them. lolnope again
---------- Post added at 22:21 ---------- Previous post was at 22:20 ----------
lol its been booting.......
NOpe i think he means it boots both lolso it boots with original nand but not glitched nand ?
lol no it will boot with any image i put on it...so it boots with original nand but not glitched nand ?
Tell all your friends you coded it yourself lol and your the only one that has itWell if it boots you can just pass it of as a new lighting mod lol
Well if it boots you can just pass it of as a new lighting mod lol
hmm I just think I will.....Tell all your friends you coded it yourself lol and your the only one that has it
or like 5 billion pesos!!!!!!!!!!!!!!!!!!!!!!!!!!you could probably get atleast a 1000$ for that
lolor like 5 billion pesos!!!!!!!!!!!!!!!!!!!!!!!!!!:biggrin::biggrin::biggrin::biggrin:
oh wait not the best plan
yesVery strange that this happened after you tried to update. Just so it's clear to me, you did try this with a previous nand it's still dong the same thing? It sure looks like a hardware problem put I suppose it is possible it's a software issue to.
sounds like a solid theory to me do you by any chance have your old freeboot image left you could try to write that back on and see if the lights go awayyes
my theory is (dont laugh) but while updating there was something 4 the rol board...and it (obviously)failed:facepalm:
well its bed time 4 bonzo so ill try tomorrow.....It's more likely a hardware failure. Take your console apart and see if the board is loose. A bad ground can cause strange problems.
well its something to try....your in luck as i have seen this before on my of my first jtag consoles, somehow i damaged the port that the RF board plugs into, i de-soldered it and replaced it with one from a bricked console, and it never did it again. give it a try if you want but like the other guys say make it into a nice console mod with a nice modded case
edit - i damaged it by trying to remove the mobo without realising the RF board was still connected