ANSWERED doesnt boot into xell

R

rexdale

Full Member
Jan 7, 2012
34
0
read nand fine. installed coolrunner, think i messed up cpu_pll_bypass, so tried the alternate point.

I dont have a good enough camera to take a pic. I think it soldered on fine, but not sure if i scrapped the point properly.

When i try to turn on 360, nothing shows up. I tried turning it on with the power plate on it, and i get two red lights blinking on the right and the green light in the middle flashing.

I have a feeling i may have blown one of the resistors near the cpu pll bypass point, but don't have a multimeter to check. I'll buy one soon.

Anyone else think something else may be the problem or have any suggestions?
 
Krafter

Krafter

VIP Member
Apr 17, 2011
3,737
118
Indiana
99% sure it's soldering. You probably should stop now and send it to someone to fix and finish the job for you. You have already tried alternate points. If that fails then you done.....
 
RROD!

RROD!

VIP Member
Apr 13, 2011
786
0
to tell you the truth buddy you got no cam no multimeter so if you cant start and rule them things out then there is no point in guessing or going any further yet..not till you can get cam and multimeter
 
RROD!

RROD!

VIP Member
Apr 13, 2011
786
0
FreakAlchemist said:
I didn't have a multimeter or camera and everything turn'd out fine for me.
Click to expand...
lol and your point is??your not the one in here asking for help and your not the only one on here that can install a cr with no probs i mean hell is it the norm that a install should go tits these days????lol:crazy:
 
You must log in or register to reply here.