JASPER don't boot xell

[wojtech.nettle]

Console Type: Jasper
Programmer JRP v2.0
NAND Size: 16
Dashboard version: 2.0.17150

CB Version: 6754
Screenshot of NAND details from J-Runner:

J-Runner log

Checking Files
Finished Checking Files
Initializing nanddump1.bin..
Jasper 16MB
Jtag Selected
Nand Initialization Finished
Comparing...
Nands are the same
R-Jtag Selected
Aud_Clamp Selected
Patching Jasper version 2.3 SMC at offset 0x12BA
XeLL file created Successfully jasper_hack_aud_clamp.bin
Version: 01
Flash Config: 0x00023010
Writing Nand
jasper_hack_aud_clamp.bin
Done!

in 0:18 min:sec

updflash.bin log (if applicable)
Image of the CR4 XL

Images of close-up soldering to motherboard (attach images to your post)

Detailed Description of the Problem

I read nand twice, then I created ecc image (j runner-log), and then I wrote ecc. Xbox still does not boot (glitch) Xell. I've tried various DIPS (all off, 2,3,4) in combination with a jumper (330,470) on JTAG QSB. The green LED is still flashing, but the console does not boot.
Was the console working before you started: Y
Do you get a green debug light appear on the CR4 XL chip every 4-5 seconds: Y
How long is the light on for each time (be aware that if you're trying to work on a faulty console, this is not a T-X product issue!!).

 

[stucknvegas]

Whats with the green E-wire that connection is for RGH-2 + only

 

[gavin_darkglide]

read the r-jtag+ install guide again, the d pad is only used on slims, get rid of the green wire, and put the blue wire on m, flash jtag aud clamp ecc, and I bet it boots fairly quick. if you go with rgh2+ wire up green wire, and remove A, and B wires and move blue wire to G. Also need to set switch to phat, and set jumpers according to the guide.

 

[wojtech.nettle]

Yes you are right, my mistake. I had previously done RGH2 + also without success. Green wire is desoldering and now I'm going to try.

 

[wojtech.nettle]

UUps...basic mistake. I resoldered blue wire to M (Green wire is desoldered). Now green LED is not blinking.

 

[stucknvegas]

It is hard to see some of the solder points You need up close clear pictures Move the yellow wire out of the way of the AUD clamp and give us a clear picture ..The same for your top QSB V-3 is the QSB soldered at the B-point connection R4b24 pad ??

 

[wojtech.nettle]

I am sorry for the pictures. Problem solved. I remade installation back to RGH2 +. Previously, it was an error in the placing wire to point D. Now the console boots consistently 1-2 glitch. Anyway, thank you for your advice.