Ok I ditched that crap product and am supposed to get my demon today. That said I soldered to and from nand pins did several rgh installs and soldered to and from the I/0 0 to 7 a few times no issues there. Now when I solder a connection to I/0 0 or I/0 1 the console does not boot and there is for sure no bridge. I tested those points with a multimeter and each point gives like 9.90 with it set to ohms but I/0 1 flashes like 17 real quick and stays with no reading I can do the alternative nand pin points if I have to id just rather figure this out thanks guys.
FIXED Dual nand points
- Thread starter x ModzGalore
- Start date
DreamZ
VIP Member
Clean up all points. Remove that pos you have on it atm and get it booting stock from stock nand.
BrockThunderjam
VIP Member
- Jun 25, 2013
- 1,503
- 88
lol ya that thing is a pain I mean it isn't hard just time consuming. That's why I had to just order a demon much faster and pro looking.
Ok well that's the thing I removed it but if I even solder to point I/0 0 and 1 then it acts like theres a bridge. I used desolder braid and rubbing alcohol on a q tip but really just that one point I/0 1 makes the console not boot and it doesn't have the 9.90 reading on multmeter like the other points in the row idk weird I see no bridge.
TheGlow
VIP Member
Looks like the IT closet here.
Just need some meatballs, and its spaghetti and meatballs for lunch.
Ya the wiring is a joke but as i said i want to put this demon in and the i/0 1 point and i/o 0 point are acting like there bridged. The other points all read besides i/o 1 on the multimeter i cleaned it and everything. Any thoughts?
Martin C
VIP Member
Remove everything you've soldered.
Clean up properly.
Then complete the template PROPERLY if you want help.
Clean up properly.
Then complete the template PROPERLY if you want help.
Ok heres my template, Nand-x, DGX V1.1s, and demon my console type is Trinity dashboard 2.0.16203 16mb nand abd yes the point worked and gave me a reading prior to this. I don't really have logs I dumped 2 copys of the nand which matched then extracted the cpu key with dgx now im stuck with this I/0 1 point when soldered to console wont boot.
Hey thanks guys I sorted it out I reapplied solder to the points took some braid to them used my other flux by the way. Then just ran a wire from each point to nothing and it boots. Before it wouldn't so sweet thanks martin if I need help with this demon ill see what's up but I should be fine.
Martin C
VIP Member