Dummy.bin from key

[theball]

Hey, i have a xecuter replacement PCB and i wanted to extract the dummy.bin, i followed the tutorial but idk why I kinda failed, however I did manage to extract the key file, my question is: Is there any way to generate the dummy.bin with the key file?.
Sorry if this is a stupid question I'm just starting with all of this, thanks a lot.

 

[v0rtex]

"DummyGen" under DVDKey 32 will do that for you but you need to also have Inquiry.bin & Identify.bin which you should have, since you probably extracted the key but didn't have the option "Dummy.bin Only" ticked on the top right corner.

 

[Oggy]

Why not just read the full flash?

Sent from my GT-I9100 using Tapatalk

 

[Blujay]

you can use the original firmware in the firmware pack for your drive and insert your key into it with jf. That should work just fine.

 

[Oggy]

So much poor and misguided information in here...

If its a replacement PCB its gonna be a slim.

1. Jf log shows nothing of great importance.

2. Dummygen won't work alone because of 0x2A000 sector.

3.0x2A000 needs to be recreated for you to use the ofw in the pack.

Sent from my GT-I9100 using Tapatalk

 

[Blujay]

My bad, then you need to do a full dump.