Dvd drive isnt working

ijurmyi

Noob Account
Dec 27, 2010
2
0
When i was flashing a 93450 i used the phatkey and probe like usual but then my computer froze and i had to restart my computer.
i went to try again then i realize that i rebooted my computer to orginal and i didnt have xecuter ck3 pro installed in my computer and now the dvd drive doesnt show up, it wont eject the tray. i also put in back in the 360 and the shows a blinking green light.
 

Goldensavage

VIP Member
Jul 26, 2009
3,332
0
Essex, UK
Best suggestion.

Load everything up as normal, install all the drivers. and get your JF up.

Make sure that the port is the correct port for that particular drive. even if it doesn't show up in JF. Then press Intro/Device Id, and turn off/on within 1 sec. It should send the required details and put the drive in vendor mode. and be visible again.

Press Outro/ATA reset and the drive should be back to normal, with all intact.

And ready to try again. or follow the link in my sig below. But that if for mainly if you have your drive key

UNDER NO CIRCUMSTANCES SHOULD YOU PRESS ERASE TO DO THIS UNLESS YOU ARE SURE YOU HAVE YOUR CORRECT BIN FILE
 

ijurmyi

Noob Account
Dec 27, 2010
2
0
i tried doing that and it doesnt go into vendor mode. it shows Status 0x52 and 0xD2 when i turn it off and on.