RGH E71 after flashing bin

S

Stormtrooper

Full Member
Aug 30, 2011
61
0
Ok, this is driving me nuts.

I used nandpro to dump my nand 5 times. Each time it found a bad block at B2 (204) and another one at 2A2 (250)

From reading a few posts it said I shouldnt worry as the bad block is below 50. So I create the ecc file - write it to the nand, it boots into xell fine - I get the cpu key and create the nandflash.bin (Using 360 multi builder 0.82)

Put rawflash v4 and the bin file on USB - boot up the xbox and it flashed the bin file. It gives my 2 warnings.

block 0xb2 seems bad (204)
block 0x2a2 seems bad (250)

This seems right as it matches the above. However now on reboot the xbox dash boots and right after I see the logo I get a E71. I can still boot into xell.

I've recreated the bin - same problem. I've also tried to remap the bad blocks using the jtag tool but when I view the bin with 360 flash tool is shows:

Note: Bad block ID 0x02A2 [ Offset: 0x00ADC400 ]
-> Block ID 0x2A2 found @ 0x3FF [ Offset: 0x0107bE00]

Any ideas?
 
A

AteOeight

VIP Member
Feb 22, 2012
278
0
Hawaii
E71 is a hardware failure, someone correct me if I'm wrong. Also, I hate to say this, but you won't get a lot of help without posting pictures of your install. Get clear, detailed pictures that's the only way you can get better help around here.
 
S

Stormtrooper

Full Member
Aug 30, 2011
61
0
Ok - this is weeeird :)

I flashed the original bin back and rebooted the xbox - it gave me the screen where the dash update failed. I should have checked this before I started - the guy that gave it to me obviously tried to update to 13599 off a backup and after reboot it gets stuck. So I finish the update, reprogram the ecc and now its kind of working Interesting enough there's only one bad block showing - 2A2.

Its now loading up the 14719 dash and all appears ok, except I can't power it off. If I click on the "turn off" button I hear a beep, the screen freshes but it doesnt turn off. If I then hold down the button on the controller to power off - it hands the console. Have to pull the power plug.

The reset seems to be working find though as I've put xexmenu in the CD and I can run it.

Very odd. Problems with 14719?
 
Martin C

Martin C

VIP Member
Jan 10, 2004
35,981
0
Scotland, UK
www.team-xecuter.com
Might be taking corruption etc from your original NAND.

Create a retail 14719 image (so it's clean), then use this to make a new RGH image.
 
You must log in or register to reply here.