ANSWERED e71 cant update

S

SLIMaxPower

Noob Account
Jan 16, 2012
7
0
hi. got a falcon jtag ( someone else did it )that has e71 error. removed hd booted xell and tried to update.

rebuilt nand with latest dash with multi_builder_07, put the nanddump.bin (also tried updflash.bin) and xenon.elf on root of USB stick, booted xell.
The first few times xell complained of transfer errors. Swapped to different USB sticks. Went to a black screen with white text. rawflash started, etc, initialized controllers etc, then

* trying to make sense of uds, lets assume its fat.

And it just sits there. Leave for 5 minutes, unplug power for 30 secs - repeat process.

need some advice. cheers
 
TilVl

TilVl

VIP Member
May 11, 2011
1,383
0
Try to update it through nand-x or lpt.

Sent from my SGH-T839 using Tapatalk
 
S

SLIMaxPower

Noob Account
Jan 16, 2012
7
0
as I said in my post I didn't do the jtag and don't have the gear.

This is not the first time this has happened either. Using Dashlaunch and Freedash consistently.

What is causing the corruptions ?
 
C

cfull1

VIP Member
Mar 10, 2011
156
0
Texas!!
Which version of rawflash are you using?
You should use version 4. Replace the one in multi builder and on your usb drive.

---------- Post added at 17:03 ---------- Previous post was at 16:55 ----------

Also make sure no other usb drives are plugged in.
 
C

cfull1

VIP Member
Mar 10, 2011
156
0
Texas!!
Are those two bad blocks remapped? You can check in 360 Flash Dump Tool.

Do you have a hard drive plugged in? Try removing it.
 
S

SLIMaxPower

Noob Account
Jan 16, 2012
7
0
no hd in. it is an instant e79 error, whereas the e71 error was after Xbox 360 boot logo.

havent checked the errors yet, but the original NAND I got of the jtagr had the same errors if that helps.
 
Martin C

Martin C

VIP Member
Jan 10, 2004
35,981
0
Scotland, UK
www.team-xecuter.com
There is zero point in you continuing unless you know what wiring you had in place.

My first advice would have been to dump the existing NAND and open it in a utility which will detect what SMC config you have. As it stands now, you're in a state of limbo and can't do anything more without a hardware flasher.
 
S

SLIMaxPower

Noob Account
Jan 16, 2012
7
0
hi assumed that.

one of the tools I used to create the NAND said it was a normal SMC.

Before this happened I flashed the console with the NAND the jtagr sent me, and still had e71 error.

anyway thanks for the help

cheers
 
Martin C

Martin C

VIP Member
Jan 10, 2004
35,981
0
Scotland, UK
www.team-xecuter.com
Did you check the SMC version in the one supplied?

CMD Freebooter will do this for you and give you a good indication as to what wiring was used.

TBH the person you bought it from should have told you if it used wiring outwith normal configuration (as I would have done).
 
You must log in or register to reply here.