E71 error after installing freeboot

[dube70]

It all went well, I wrote the xell file and created freeboot and wroted to the console. Now it's boot up normally but after a few sec it's E71 on me. What would be my problem? I done the 2 diode and got e79 change it to the
the 3 330 ohm resistor and got write freeboot but now e71. I try both xell and xellous. what wrong

 

[keil423]

What kind of mobo is it? post some pics of your install please.

 

[manwithoutname]

Lack of details, which board do you have i.e. xenon, zephyr, falcon, jasper? Are you using QSB or wires?

Try re-flashing xell first and see if you get that working!

 

[dube70]

The mobo is a xenon and the wire are directly solder on the mobo. is e71 a dash board error

 

[manwithoutname]

Like I said before and with bit extra:

1. Try re-flashing xell and see if that boots?

2. Re-compile freeboot then re-flash and test again?

 

[dube70]

hope the picture are ok. While installing freeboot I have 1 error coming up error202 programming block A9

 

[M AzeeM K]

E71 means that there is some problem with the Dashboard System files. Try making a new freeboot image and writing it to the NAND. Also, remember to remap bad blocks.

 

[dube70]

Thank MazeeM K for your time, my problem was bad block, after learning how to remap, the problem got solve. E71 is a dash problem

 

[M AzeeM K]

^ Glad to help