RGH E71 on Demon NAND

B

Bong420

Senior Member
Mar 23, 2005
147
0
Where you live?
I got it to boot fine on stock nand. The DemoN has bad blocks @ 40 and 164

I think the reason is because of the bad blocks @ 40

Is there anyway to resolve this?

The system is a Trinity Slim. CR3Lite. Boots Stock nand no problems. Demon Nand seems as if it will boot then throws up E71. Its glitching just fine.
 
Krafter

Krafter

VIP Member
Apr 17, 2011
3,737
118
Indiana
To see if its remapping the bad block. There should be a log file in the JR folder. Open it with a text editor and copy and paste.


Sent from my iPhone using Tapatalk
 
B

Bong420

Senior Member
Mar 23, 2005
147
0
Where you live?
Krafter said:
To see if its remapping the bad block. There should be a log file in the JR folder. Open it with a text editor and copy and paste.


Sent from my iPhone using Tapatalk
Click to expand...
There is no bad blocks in the stock nand.

Checking Files
Finished Checking Files
Initializing updflash.bin..
CpuKey is Correct
Key already Exists
Nand Initialization Finished
DEMON
Hardware : Demon Slim
Firmware : 1.0
Flash ID : 0x73AD Hynix (16MiB - Small block)
Flash Size : 0x400 blocks of 0x4200 bytes
Invalid Blocks : 0x28 0xA4
Writing Nand
Done!
in 0:28 min:sec
 
Last edited:
B

Bong420

Senior Member
Mar 23, 2005
147
0
Where you live?
Ok I figured it out myself.

I opened up Demon Toolbox

Read NAND I had already written to the DemoN
Saved it as a new nand.
Opened up JR, opened up the NAND I had just read in Demon toolbox, then put in CPU key again, created another image since the one I just read will no have the bad blocks in it and it remapped those bad blocks in the new image.

Thanks for your help, your mentioning it not remapping the blocks made me think since the stock had no blocks that were bad, it wasnt building an image for the demon with remapped blocks.
 
You must log in or register to reply here.