This is my second install of the CR and everything went smoothly, I've even using the box for the past two days. Yet, now when I try to boot it with the power button or controller I instantly get an E74 but I can boot it with the tray button and run Xell all day without E74 or any other errors. I checked the swithces on the CR and its set to PHAT and NORMAL, I'm at a loss. Im trying to flash the stock nand on it through Xell but it keeps freezing at *trying to make sense of uda, let's assume it's FAT. Any ideas? If it helps it's a Falcon mobo with a cap on the CR.
E74 Error After CR Install
- Thread starter Dark_Phoenix
- Start date
Post secondary code and yes xell will work on an e74 console. You could have pushed the console overboard and after running for a few days it went down the toilet. Sounds to me the console was already headed that way it was just given the push it needed. It's most likely freezing because of the e74
Last edited:
E74 is hardware for sure and if it was freezing after RGH install and now is E74 it is more than likely that the freezing was just the warning for a failure (E74). A good reflow or reball is probably best.
This box doesnt have XClamps, it uses screws with plastic washers. Ive tried flashing the stock nand but xell freezes up when it tries to read my flash drive though it let me reflash the glitched image. Im just at a total loss. How much does a reball or reflow usually cost?
Just performed the secondary test, the code is 1022.
Just performed the secondary test, the code is 1022.
Last edited:
BL4K3Y
VIP Member