E79 after flashing

[Sovereign.]

Here is what happened:

1)I flashed my Freeboot image using my Nand X, and nandpro, and I got no errors.

2)When I boot my console it just hangs at a black screen.

3)Flashed Xell, after xell booted up I flashed my freeboot image which gave me about 15 "Block # seems bad: 0x00000210" errors and 2 "Block # seems bad: 0x00000208" errors while flashing in xell.

4)After I restarted my console I get an E79 after four seconds.

5)I flashed my retail image using nandpro and my Nand X and received no errors.

6)When I started my console I received an E79 after four seconds.

Background: Had Xmods do my coolrunner install and when he shipped it back to me it booted up into the hacked nxe. I decided I wanted the 13064 dashboard and made an image with my original nand and flashed it to the console. I did not know about the LDV values then and spent my entire saturday sorting that problem out. After I got my LDV matching my console get's an E79 after I flash my original retail nand and my freeboot nand.


Falcon motherboard
Dash 14699
16mb nand size
The CB of my original Nand is 5771

 

[Martin C]

What did you use to build your image?

Any bad blocks in your original NAND dump?

Make sure you're using rawflash v4 if you're looking to flash from XeLL.

PS - do you understand the part in my sig which says 'do not PM me for support' ?

 

[Sovereign.]

I honestly did not read your sig martin and I won't pm you.

I used my original nand with 360 multi builder

There were 0 bad blocks in my nand when I compared them.

I did not use rawflash v4. I will try that right now and post results. I also tried flashing with my Nand X so it should not matter but I will try it.
___________________________________________________________
Edit- Using the xenon.elf from rawflash v4 did decrease the number of #seems bad errors to six but now my console boots and just hangs there on a black screen and does not show a E79 like it did before. Xell boots up using the eject button though.

 

[Martin C]

You shouldn't get any bad writes via rawflash - make sure your NAND-x soldering isn't causing the problem.

 

[Sovereign.]

When I flash my original nand dump I get a 0022 (E10) after some time. But when I flash any other nand I get an E79 (shows me an error on my screen). I am just throwing out the only other thing I can think of here. I did solder a wire to a mosfet I used to draw 12v of power for the fan. I did this when my nand was messed up and I couldn't boot. So it was not on there very long before I soldered it to the spot on the underside near the psu as it is safer. After I figured out my nand x would not get detected in nandpro unless my av cable was plugged in I was already receiving the errors.

Could a mosfet or a bridged solder point (I checked for a very long time and I do not see any) be causing these problems? I have tried writing every build I had or made and none of them have worked. They ones that have xelll boot to it just fine with the eject button though.