hi all im new to this so go easy i have a xenox board that is exploitable i have dumped the nand 3 time and compared no bad blocks got my cpu key fine installed xbr but when i tur on goet e79 with jtag swich off if on i get fragging lights can anyone help?
E79 after writing XBR.
- Thread starter kevdunne3
- Start date
BGAMods
VIP Member
Re: Xenon - E79 After Xell ? New JTAG Kit Available
fragging lights???????? the switch needs to be on but try the other resistor settings.
fragging lights???????? the switch needs to be on but try the other resistor settings.
sorry i should have been more specific ive used a usb nand x tool and the kit seems to be installed and solderd fine dumps were fine when mached but when i power up the xbox with swich on the lights on the front flash red top two and gren bottom 2 the vise verser but if the jtag swich is off i get e79 error if i boot up using eject key i see the blue screen where my cpu key is thats fine too.
BGAMods
VIP Member
on the nand-x qsb there 4 settings on the switch. off, 0 330 and 440. try the different settings.
tried both still the same if swich is off e79 error if one 330 or 440 flashing red and green light?
[ame]http://www.youtube.com/watch?v=dBU0l0YJO0o&feature=related[/ame] this is whats happening when i power up
how do i get back to my normal dashboard as ive wrote over my original when i installed freeboot using jtag tool and nand x installed xel
BGAMods
VIP Member
i saved it but after reading nand with jtag tool but when i wrote xell it wrote it on that save but the dump was fine xell came up ok got cpu key ok then i removed xell and enterd cpu key into jtagtool and created .bin file then wrote.bin file is there any way to put it back to normal and flash it back to the nand?
BGAMods
VIP Member
yes i saved it and the dump was ok but wrot xell to it turn xbox on and got my cpu key fine but then when i removed xell and wrote freeboot this happend?
like a noob in my sucsess once but when i tried later 3 times no bad blocks could this be my soldering?
BGAMods
VIP Member
could you tell me how to write it back as i dont want to use jtagtool dont trust it i saved origina nand as nand1.bin
BGAMods
VIP Member
use nandpro and a cmd prompt. have you used cmd prompt with nandpro before? or you could use jtagtool and click remove bin and when it asks what file select your original nand dump and it will write it back for you. that should be fine.
Last edited:
yess i find it a bit mor technical but safer but what would be the command to write the original image?
BGAMods
VIP Member