JTAG e79 after writing xell

[dube70]

I may have done something stupid, I solder all 4 pad that came with the nandx reader, is that wrong? the 2 pad for the nand and the 2 for the jtag. Do I need to remove the 2 pad for the jtag part off? also if I need to rewrite the nand what software do I use?

 

[Martin C]

Take a picture of what you've already installed.

 

[keil423]

use jtag tool by cool shrimp


http://www.team-xecuter.com/forums/showthread.php?t=54178

 

[dube70]

Here's some picture as requested

 

[bandit123]

picture 1 that board look damaged mate looks a bit fried TBH

 

[rdubbs007]

I cant see anything it is all too blurry...

 

[dube70]

this picture are better

 

[Martin C]

What did you use to build Xell or Freeboot?

 

[dube70]

Jtal tool v3

 

[Martin C]

So you opened JTAG tool, selected USB and Xenon from the top and clicked Dump NAND. You then clicked 'write XeLL' ?

 

[dube70]

Right

 

[Martin C]

show a picture between J2D2 and J1F1 with the wires connected...

 

[dube70]

here they are

 

[Fisticuffs]

Have you tried moving the switch on the jtag QSB and booting it?

 

[dube70]

It's keep telling me can't not find flash controller. I tried all the switch position and jumper

 

[Martin C]

It's keep telling me can't not find flash controller. I tried all the switch position and jumper

Switch positions and jumper are not going to help with finding the flash controller.

The finger is pointing at your soldering I'm afraid. You need someone to resolder this for you.

 

[dube70]

What do I need to resolder? the jtag part

 

[Fisticuffs]

These are questionable

 

[Martin C]

What do I need to resolder? the jtag part

You don't need to resolder anything. You need to get someone to resolder for you.

 

[bandit123]

pic 4 the solder isnt even touchinh the board and it looks burned what iron u using and are you using flux????