hey guys, i got a falcon jtag here with me, it has E79, i know that it might be the wiring, i didnt wire it or anything, a guy dropped it off today. he didnt give me any details, i sent him an email about that, ill post them later. the secondary error code is 1033. its not the hard drive, i took it out and still e79. what can i do to fix this? i can show pics of the wiring soon, im not sure if he has the original nand i asked him, but hasnt emailed me back. thanks.
JTAG E79 falcon jtag!!
- Thread starter xbox360mod
- Start date
Martin C
VIP Member
ok, heres the info he gave me, he gave me pics he got from xell, he said he was on dash 8995, then his xbox dies after he was finished putting latest dash on it, thats all he said, could it be the wiring?
Last edited:
J2G
VIP Member
could it be the wiring lol how do we know you haven't posted any pics of the MB with the wiring its a falcon board so it can be wired ass ways for all we know..have you even opened it 
J2G
VIP Member
Well thats up to you xbox360mod i did wire the falcons one time but i every now and again id get E79 i never got it again when i started using QSB Kit #2 ..i never put the diodes in the J2D2 ether look at the pics below..
Last edited:
keil423
VIP Member
Id say its a problem with the writing of the freeboot. I think you need to get the OG nand back bud and start over.
Martin C
VIP Member
Now take a pic of the underside where R6T3 is.....
No offence - do you need to have your hand held in order to know what information you should be checking???
No offence - do you need to have your hand held in order to know what information you should be checking???
If you ask me, it seems like the person who have you this Xbox360 tried to update to freeboot which had the wrong SMC in it, therefore it got the E79. I suggest you solder the NAND QSBs and write XeLL. If it boots, then you can proceed on to freeboot. Otherwise, its probably the Jtag writing causing E79.
Martin C
VIP Member
TBH the top wiring looks fine and if it's not been touched between working and not, we can rule it out. I would therefore agree with M AzeeM K in that it's more than likely the SMC is wrong.
Martin C
VIP Member
alright, there is a good chance that he doesnt have his original nand, hes trying to contact the guy he bought the jtag off of. if he doesnt have the original nand, what could i do? could you just point me in the right direction, im not asking for a full tut here.
alright, i just checked under the mobo and the efuse isnt protected. the R6T3 isnt removed nor the solder points are bridged
J2G
VIP Member
If you don't have the the nand your going to have to use a donor nand coolshrimps Jtag tool has donor nands you will have to use 360 Flash Dump Tool v0.97 to inject your the CPU Key.
J2G
VIP Member
Not atm buddy your ok your not updating or using anything that will update it and anyway to update you have to accept it i'm sure your not that stupid to say yippee i got an update for my Jtag lol
hahaha lol, you just love makin fun of me dont youNot atm buddy your ok your not updating or using anything that will update it and anyway to update you have to accept it i'm sure your not that stupid to say yippee i got an update for my Jtag lol