e79 on corona v6

M

moody_007

Full Member
Oct 21, 2012
63
0
hi guys i tried to get CPU key from Corona V6 Winbond to install LTU on it so i started as usual installed TX R/W Kit got my nands and wrote the special ECC files for Winbond's installed my DGX got my keys wrote the original nand now im getting E79 error on retail image im 110% sure that there is nothing wrong with the board i searched for E79 and found that it could be GPU Issue but the strange thing this issue happened to me before and fixed it by cleaning the Mobo and the console start working again i tried to clean it but it didn't work
any ideas about this ?
i don't have anything installed on the mobo for Pictures but i can post some Pictures for the board if this help
 
A

AllyNerd

VIP Member
Feb 25, 2013
1,179
0
Philadelphia
Ya prob something y u soldered to post pics of everywhere you soldered to. And triple check for solder splashes or anything out the ordinary
 
T

taku9

Junior Member
Mar 3, 2013
12
0
What about nand you wrote? Read it again and compare with original.(If you are sure that first nanddump was OK)
 
M

moody_007

Full Member
Oct 21, 2012
63
0
no errors its 4gb Nand tried to erase and write the original nand again but no luck and when i tried to build hack image i get normal debug and then black screen after successful glitch i think something wrong with SMC as i read this before on old post
 
M

moody_007

Full Member
Oct 21, 2012
63
0
Well this will drive me crazy i tried to erase my nand AGAIN but this time took 6 minutes not like the others 4 minutes and wrote the original dump and the console booted to dash i done this before but when i erase my nand and take 4 minutes nothing change but i tried once and took 6 minutes and booted to original dash but when i write the glitch image the console will stop booting and original will give me e79 again so I decided to stay on original and install LTU on it
Thank you guys
 
You must log in or register to reply here.