Eject/Power LED Mod

[santium]

I read the tutorial on XS about making the eject/power led half green/half red.. I've tried to figure it out, but I can't. What wires would I swap to make it half red/half orange? Because that would match my paint job.

 

[Biohead]

I don't think it would actually be possible, as orange is created bu turning on BOTH the green and red lights at the same time, but someone may correct me on that.

 

[r3lik1]

I read the tutorial on XS about making the eject/power led half green/half red.. I've tried to figure it out, but I can't. What wires would I swap to make it half red/half orange? Because that would match my paint job.

what chip do u have??

 

[matt77303]

you can do it by editing the bios. sither in xbtool if you have a x2 or the config.ini on the newer bios's, or if you have a x3 you can do it via config live.

Matt

 

[skatersully2010]

You could follow this tutorial:

http://forums.xbox-scene.com/index.php?showtopic=50825

or, I've specifically told you how to do exactly what you want here below:

I suppose that you could also swap wires 5 & 6, and then short wires 7 & 8 to each other. This would give you red on the left, and orange on the right. For orange on the left and red on the right, simply short wires 5 & 6, and then swap wires 7 & 8. If you don't know which wires i'm talking about, here is a picture with wire lables and numbering.

 

[punisher84087]

you need to bridge the positive leads on the leds to get orange

 

[skatersully2010]

you need to bridge the positive leads on the leds to get orange

Which is pretty much what I said, however, take note that the orange half won't be as bright.