just as was putting my console back together , i went and caught the wire to the d pad on jtag and bloody pulled it off , any way i can solder it to anywhere else , after bloody nearly a day trying to get it to boot with rater i go and do that lol
GENERAL emergency pulled d pad
- Thread starter briggs01
- Start date
BL4K3Y
VIP Member
Post an image showing the damage.
If you've lifted the point shown in the R-JTAG images, you can solder to the R8C2 resistor on top of the board.
If you've lifted the point shown in the R-JTAG images, you can solder to the R8C2 resistor on top of the board.
if you damaged the r-jtag then i think its the edge-side of C23
if its the motherboard then as BL4K3Y said, R8C2
if its the motherboard then as BL4K3Y said, R8C2
BL4K3Y
VIP Member
Woops!
Get your multimeter out and do a continuity test from the pad D trace against the pins on the IC and solder your CPU_RST wire to the pin your multimeter "beeps" on (a thin wire is recommended).
If I recall correctly, it is the 8th or 9th pin from the left if you are looking at the IC from the side with the solder pads.
Last edited:
no mate cant find anything , its not a gob for me im afraid , looks like ordering an new batch
- - - Updated - - -
- - - Updated - - -
sorry mate that would be easy if its that
here you go mate my rater i was telling you about after soldering the wire , it doesnt stop i have to click stop
BL4K3Y
VIP Member
Last edited:
From the looks of the RJTAG wiring picture you provided, it looks like the K wire (Kiosk, is used for turning the console on/off) might be pinched or damaged at a pinch.
This might be preventing your console from turning on/off
As for the loop you have posted in the the quote I would check your post out and cpu_rst
Last edited:
il check that tomora mate , its the cpu rst wire pad that is broke , i have soldered it onto the side of the c23 as adviced above
DreamZ
VIP Member
Err. Kiosk is used to turn the Xbox on. Green nand wire turns it off. If his kiosk was in trouble wouldnt his Xbox not turn on via rater?
the cpu rst pad is damaged,so it will keep looping sort of speak..as it cant boot.coz no contact..between the D point on the r-jtag and the console..
the OP is prob best posting images of his full install..
Martin C
VIP Member
Who advised you to solder it to C23? He said you need to expose the trace leading to the IC.
If you need more advice other than the lifted pad, please fill out the template form and include ALL pics.
shuttleu
if you damaged the r-jtag then i think its the edge-side of C23
if its the motherboard then as BL4K3Y said, R8C2
if its the motherboard then as BL4K3Y said, R8C2
i said "I think"
I'm still waiting for mine to come from Mr Modchips (been waiting over 2 weeks) hence WHY i said "I think"
it looked like it went to C23 from the image here
I expected you to check it first
Last edited:
o lol good job i didnt blow my jtag up then but on the other hand i shouldnt just take anyones word for it unless its a super mod , got it sorted now mate , having trouble getting it to glitch tho , tried all settings on dips etc and 1.8v on jtag and no jumper on jtag , give up for today , will try 1.2 tomora and then start on aud clamp off
Last edited: