Team-Xecuter Community

Hi,

I recently upgrade the system firmware via ChoiDujourNX. However, I used the default setting that will enable the AutoRCM. However, after I update the system firmware successfully, I found that I still need the jig and loader and hold vol+ to start my switch. If I only press the power button, it goes to the original system. If I plugin the loader only and press the power button only, it goes to the original system as well. It seems like the AutoRCM enabled by ChoiDujourNX doesn't work at all. But I am sure I never changed any setting when I update the system firmware, so it should enable the AutoRCM by default.

I am wondering if AutoRCM is enabled on my switch, maybe I am worried for nothing.

Thanks