GeekHeat
VIP Member
Maybe I'm wrong but his cb version in his log is 4570. Which is old dash as jtaggable. So the cr4 will not work as he is not on the latest dash. If I'm right then the op can just jtag it and no need for a glitch chip.
ZEPHYR Error 0022 after R-Jtag install
- Thread starter MopedMan
- Start date
Taijigamer2
VIP Member
WTF? He's got a jtagable box! Completely missed that. Why the hell is he trying to glitch it?
Op - if u ever sort out the 0022, just jtag that box. To run rjtag the dash needs to be on 15574 or above. Jtag only requires the jtag qsb and a jtag NAND to boot. Save the rjtag for another box.
I wasn't aware it was JTAGable!
So if I unsolder the CR4 from the board, and just dump the NAND with Xell it should work? As long as I have the JTAG QSB soldered?
If this is the case, can I leave the other QSB (the one which the CR4 is soldered to) on the board, or does that have to be removed?
So if I unsolder the CR4 from the board, and just dump the NAND with Xell it should work? As long as I have the JTAG QSB soldered?
If this is the case, can I leave the other QSB (the one which the CR4 is soldered to) on the board, or does that have to be removed?
Taijigamer2
VIP Member
If u have used the nandx qsb and jtag qsb, just leave them in place, they will be more of a problem to remove, and the jtag qsb is what u want anyway. Just write a standard jtag NAND and remove cr4 + wires and xell should boot. Good luck.
Last edited:
Yeah I have the NAND-X and JTAG QSB's installed, but I also have the JRP/NAND-X/CR QSB soldered to the board too? Will I try remove that on also, or leave it be?
Taijigamer2
VIP Member
Yes I meant that one too. All can be left onboard. Just remove cr4 and wires so that it doesn't try to reset the CPU. With your dash, u only need the smc hacked NAND and jtag wiring. Enjoy.