Error 25 reading block f7

[dragontm]

ok i have done 2 nand reads and both come up with this error, this is on my jasper 16mb board?

can someone help?

 

[rocket8080]

Check your solder points especially the ground, if your getting this error constantly at the same block then its probably just a bad block.

 

[dragontm]

My solder is fine, i have used the pin headers.

so am i safe to write xell?

a question the new jtag tool it says flash xellous, if i write that do i still boot up with eject? 1 other thing when writing should the jtag switch be off, or on

 

[rocket8080]

Have you ran the nand dumps through degraded to see for bad blocks?

1 other thing when writing should the jtag switch be off, or on

doesnt matter

a question the new jtag tool it says flash xellous, if i write that do i still boot up with eject?

Yes

 

[dragontm]

Have you ran the nand dumps through degraded to see for bad blocks?



doesnt matter



Yes

when i load the nand on degraded, windows 7 programme stopped working so i cant

 

[dragontm]

can anyone get degrader 1.1b working with windows 7 64bit?

 

[manwithoutname]

Just use 360 flash tool ...