Okay so first of all lemme say that this was indeed my 1st real soldering job, so it's probably not so good. This is a normal Jasper non-JTAG, i bought specifically to this kinda of experiences.
My interest in the xbox "scene" and eventually soldering only started 2 to 3 weeks ago, so I'm kinda new to this.
I tried to install the QSB as i though it was the most easy solution. After everything was put together i got a red light in the AC brick and of course "No Flash Controller found".
With my lack of experience i tried to de-solder everything the best i could and to my surprise the console still booted up normally and worked 100%, so no more red light on the AC brick.
So i decided to continue my "adventure".
Since the QSB were probably f**ked up, and i didn't had the de-solder braid to put the pin solution, i just cut the QSB cables, tin them and solder them to the board.
The only problem was that since i didn't had the braid desolder and the yellow cable point was pretty black, i couldn't solder the cable there, so i just soldered to the back of the motherboard on the same point.
At least i could read the nand.
LONG STORY SHORT: I'm getting the error that's in the topic: "Error: 250 reading block 90"
Will i have any problem with this error? I dump the nand 5 times, and fc /b them and no differences were found.
My interest in the xbox "scene" and eventually soldering only started 2 to 3 weeks ago, so I'm kinda new to this.
I tried to install the QSB as i though it was the most easy solution. After everything was put together i got a red light in the AC brick and of course "No Flash Controller found".
With my lack of experience i tried to de-solder everything the best i could and to my surprise the console still booted up normally and worked 100%, so no more red light on the AC brick.
So i decided to continue my "adventure".
Since the QSB were probably f**ked up, and i didn't had the de-solder braid to put the pin solution, i just cut the QSB cables, tin them and solder them to the board.
The only problem was that since i didn't had the braid desolder and the yellow cable point was pretty black, i couldn't solder the cable there, so i just soldered to the back of the motherboard on the same point.
At least i could read the nand.
LONG STORY SHORT: I'm getting the error that's in the topic: "Error: 250 reading block 90"
Will i have any problem with this error? I dump the nand 5 times, and fc /b them and no differences were found.
