Error 250 using nandx

[actiondanuk]

I have jtagged sevral xenon consoles in the last few weeks, and yesterday i got error 250 for the first time, whilest using the nandx.
I have read some other threads saying that a few of these errors is not to bad, but I keep getting 10 in the same place. I have read the nand 4 times and re-checked my soldering points. But I still get these 10 error 250's in the same place.
Im not sure whether to carry on and install xell and freebot or to remap the bad blocks.

Any help would be great.

 

[manwithoutname]

250 is bad a bad block and if you got them in the same place in your all dumps then that's ok and you should proceed ahead with installing xell. In general my experience with xenons I never needed to remap any bad blocks so far, so my recommendation is to go ahead and proceed with remapping. If not working after that then you can remap the blocks.

Let us know how it goes ...

 

[actiondanuk]

Thanks for the advice. I have an original nand and one that I have remapped. Ill try the one without the remap first and see how it goes, then If I need to ill try the mapped one.

 

[manwithoutname]

Just to mention, if you need a remap then you compile freeboot and then remap it after it's been compiled. There is no need to remap the original NAND dump.

 

[bobtucker645]

falcon and I keep getting error reading 250 reading block 142
error reading 250 reading block 143
error reading 250 reading block 144
error reading 250 reading block 145

 

[BGAMods]

please start your own thread so people can help with your personal issue.

thanks

FLASH

 

[manwithoutname]

please start your own thread so people can help with your personal issue.

thanks

FLASH

I knew I would see something like this even before I scrolled to the bottom of the post. lolz ..

 

[BGAMods]

lol theres no need to jump on other peoples threads. if you read the forum rules it says that even though someone may seem to have a similar problem, start your own thread.

 

[manwithoutname]

It makes sense to me, the problem might be similar but they might be completely different or there might be different way of treating it.

 

[actiondanuk]

Hi

THANK YOU!!!!! manwithoutname .
Working with the original nand dump no need to remap.
Thanks once again you are a star!!!!

 

[actiondanuk]

Just done another xenon this time with 4 error 250's, and once again nothing to worry about. It worked with creating freebot with an original nand dump no need to remap.