error 250

[CuddlyFriction]

i get a error 250 on block 177 i compaired nands and they match now what do i do to create my ecc file?

 

[CuddlyFriction]

i downloaded a falcon clean nand and repaired using coolshrimps tool am i okay to go ahead and write my ecc file now?

 

[xblextreme]

use nandhealer 0.74 much better my opion. http://team-xecuter.com/forums/showthread.php?t=79855

 

[Mayor_West]

block 177 is way out of the first 50
u can create .ecc with original nand to get cpu key once u get there watch this

[ame]http://www.youtube.com/watch?v=-RPh1jxGOho[/ame]

it shows how to remap bad blocks for freeboot

 

[JayDee]

Just flash the ecc as said above.

Just use multibuilder to create your freeboot.bin, check the build.log afterwords, it should show you that it has remapped badblock for you automatically and use rawflash 04 to flash it when in xell.

 

[BL4K3Y]

Yes, you can use a donor NAND to build an ECC image.

You do not need to manually remap if the blocks are outside the XeLL region (0-50) because XeBuild will take care of this for you - simply build your image and write it back with RawFlash as said above.

 

[Mayor_West]

well then looks like i learned something too

 

[CuddlyFriction]

hahaha i was in such a rush to rgh hack this board i soldered point C to FT6U1 then when i was fusrated that xell wouldnt boot i kept resoldering and i think i might have soldered the 3.3v to the point beside it on the point beside it or something i did something im not sure what but now my motherboard wont turn on

---------- Post added at 11:02 ---------- Previous post was at 10:59 ----------

my xbox does even red ring it just wont turn on

---------- Post added at 11:03 ---------- Previous post was at 11:02 ----------

doesnt

 

[BL4K3Y]

Can you post some images?

I suspect you may have damaged STBY_CLK or something nearby.