Error Code 0010 After Xell

[xColorado880]

I was using the NAND-x and got three perfect dumps.(Xenon motherboard) So I decided to put on the jtag wires and write xell. I got 3rod and error code 0010 after I flashed xell and I am not sure how to fix it.

I have reflashed the original NAND and taken off all the jtag wires and it still gets 0010. I read 0010 can be from a short in the jtag wiring but that can't be it.

I even reflowed the board and I continue to get this.

Any help is appreciated. Thanks

 

[Teajunkie]

0010 is E04 (southbridge)

Have you removed the wiring from the jtag and checked it all?

 

[iloveme28]

0010 See Error E04

E04: Unconfirmed: There is a problem with the Southbridge Chip usually dealing with how it connects to the mainboard (cold solder joint/bridged solder joints)

reflow the south bridge chip and see if that helps

 

[xColorado880]

Yes I haved removed the jtag wiring and have reflowed it with no luck at all.

 

[smalltylynch]

can also be a power brick error if you have another xenon power brick around try it also try a different power point

 

[xColorado880]

can also be a power brick error if you have another xenon power brick around try it also try a different power point

I have reflowed it and that didnt work. I also tried a new brick and still no luck.

Maybe I accidentally turned the xbox on when I was reading the NAND and never realized it