Error reading blocks

[hansje2000]

Nand Error reading block.

i have 2 nand readouts.. Both have exact the same Error reading blocks output.

I did a Compair.

I used Coolshrimp 2.75

Do i have to remap the bad Blocks?

 

[manwithoutname]

Forget about remapping the bad blocks. You have mismatching blocks which means bad dumps. Re-dump your NAND again at least 3 times and double check them using nandcompare tool. mismatching blocks usually means bad soldering.

DO NOT PROCEED until you have managed to dump clean image with 0 mismatching blocks.

 

[hansje2000]

Forget about remapping the bad blocks. You have mismatching blocks which means bad dumps. Re-dump your NAND again at least 3 times and double check them using nandcompare tool. mismatching blocks usually means bad soldering.

DO NOT PROCEED until you have managed to dump clean image with 0 mismatching blocks.

I resolder the pinheaders (more flux added), readed out the Nand 3 times, and compared them (1 over 3, 1 over 2, etc etc..). All the compairs came back in:

16384 block(s) in nand image
0 non-matching block(s) found

Used Coolshrimp and NandCompare-v1.2 to check.





But ! The read errors are still there like:

Afther this, i did a reconstruct in Nand Compare v1.2 from reading 1 and reading 2 with
( compaire) 0 non-matching block(s) found. It created a reconstructed nand.bin

Im i ready to Write Xell to get my CPU Key with the reconstructed nand.bin?

 

[manwithoutname]

If you are saying you compared all your 3 dumps in one go in nandcompare and they came with 0 mismatching blocks then you can proceed with flashing xell to obtain your CPU key.

 

[GAM3x0V3R]

Yh do what manwhithoutname said just flash xell if 0 non matching blocks

 

[hansje2000]

I wrote Xell to the box, hooked it up to the tv.. Tv blue screen keeps off. nothing shows up.
Used Coolshrimp.

 

[manwithoutname]

Are you using HDMI or A/V connection? Make sure you use the component A/V (current xell doesn't support HDMI output, new release will).

 

[hansje2000]

Used the A/V, still no luck. screen keeps blue. Is there a other way to write Xell (not with coolshrimp?) Used the DVD drive button to power up. So it cant be thate.

 

[manwithoutname]

Try a different TV, what is the 360 ROL is doing? Try xell from the files in my signature. You can use nandpro, nandpro usb: -w16 filename.bin

 

[hansje2000]

Try a different TV, what is the 360 ROL is doing? Try xell from the files in my signature. You can use nandpro, nandpro usb: -w16 filename.bin

Hooked the xbox on difrend tv's and still no Xell screen,
Afther write the Xell, The power light goes on, the 360 ROL is staying off, the fan runs.

Erased the nand, and wrote back the readout backup, dash is up again.

Anybody a other solution?

 

[hansje2000]

Fixed.. always handy to put the jtag switch to 0.